Creality ceramic hotend, K1 series (new version)
On Creality's K1 series the hotend heater is ceramic and part of the assembly, so when it fails you replace the whole kit. This is the original kit in its new version, with cooling block, for the K1, K1 Max, K1C and K1 SE; Creality rates it at 300 °C. Replace it when the toolhead reports temperature errors or the hotend stays cold, once the cable and connector have been checked.
- Hotend kit with ceramic heater, new version with cooling block; part number 4001030146.
- For the Creality K1, K1 Max, K1C and K1 SE; Creality also lists the K1C 2025.
- Rated for 300 °C by Creality.
- Before replacing it, note the error code the printer shows and check the toolhead connector: sometimes the fault is just the connection.
- The same shop page carries variants for other printers (Ender 3 V3, K2…): pick the new-version K1 series one.
Where to buy it
Sold by 3DJake: on its website you see the final price, shipping, returns and warranty, and you pay there. usi3d does not sell it or take payment for it.
Link to the shop
View at 3DJake (opens in a new tab)
See price at the shop · VAT included, shipping set by the shop
If you buy through these links, usi3d may earn a commission from the shop; it costs you nothing extra. How we choose
Which printers it fits
- Creality K1
- Creality K1 Max
- Creality K1C
- Creality K1 SE
Check at the shop that the variant you choose (model, size or connector) matches your printer before you buy it.
Problems it helps to fix
Symptoms it helps with: The hotend or the bed does not heat, Temperature error (MINTEMP, MAXTEMP, thermal runaway).
usi3d's troubleshooting guides with the symptoms it helps with and its printers:
Technical data
- Brand
- Creality
- Model
- K1 Series Ceramic Heating Block Kit (New Version)
- Manufacturer part number
- 4001030146
- Maximum temperature
- 300 °C (according to Creality)
- Filament diameter
- 1,75 mm
- Contents
- 1 pc
- Shop
- 3DJake
From the manufacturer or the shop; they may vary by variant.
How to choose the right one
Make sure you select the “K1 series (new)” variant and that your printer belongs to the K1 series. If your problem is a clog rather than temperature, cleaning or replacing the nozzle may be enough.
How we choose products
usi3d shows products from other shops for their compatibility with your printer, because they help with a fault, because they ship to Spain and because the shop is trustworthy. The commission does not decide what we show or in what order.