Creality 2 m PTFE tube kit for the K1 series
On the K1 series and the Ender 3 V3 and V3 Plus, filament travels from the spool to the toolhead through a PTFE (Teflon) tube. If that tube kinks, gets squashed or rubs somewhere, it drags on the filament: the extruder has to pull harder, skips steps and under-extrusion appears, or no plastic comes out at all. This Creality kit gives you 2 m of tube with a 2.5 mm inner diameter to replace it.
- 2 m of PTFE tube with a 2.5 mm inner diameter; part number 4004200026.
- For the Creality K1, K1 SE, K1C, K1 Max, Ender 3 V3 and Ender 3 V3 Plus.
- Measure the old tube before cutting and keep the bends gentle: a route with tight bends drags on the filament just like a damaged tube.
- If under-extrusion only shows up near the end of the spool or at certain toolhead positions, suspect the tube routing.
Where to buy it
Sold by Amazon.es: on its website you see the final price, shipping, returns and warranty, and you pay there. usi3d does not sell it or take payment for it.
Link to the shop
View at Amazon.es (opens in a new tab)
See price at the shop · VAT included, shipping set by the shop
If you buy through these links, usi3d may earn a commission from the shop; it costs you nothing extra. How we choose
Which printers it fits
- Creality K1
- Creality K1 SE
- Creality K1C
- Creality K1 Max
- Creality Ender 3 V3
- Creality Ender 3 V3 Plus
Check at the shop that the variant you choose (model, size or connector) matches your printer before you buy it.
Problems it helps to fix
Symptoms it helps with: No filament comes out, Too little filament (under-extrusion).
usi3d's troubleshooting guides with the symptoms it helps with and its printers:
Technical data
- Brand
- Creality
- Model
- K1 Series Teflon Tube Kit 2M
- Manufacturer part number
- 4004200026
- Length
- 2 m
- Inner diameter
- 2.5mm
- Shop
- Amazon.es
From the manufacturer or the shop; they may vary by variant.
How to choose the right one
Check that your printer is from the K1 series or an Ender 3 V3 / V3 Plus. If the problem only appears when loading filament, check the tube ends and their couplings too.
How we choose products
usi3d shows products from other shops for their compatibility with your printer, because they help with a fault, because they ship to Spain and because the shop is trustworthy. The commission does not decide what we show or in what order.