The resin print's supports fail
4 usi3d guides for “The resin print's supports fail”, each with the likely causes, how to check which one is yours and the step-by-step fix, with each manufacturer's official sources.
2 apply to any resin printer and 2 are for Anycubic and Elegoo printers.
Each guide summarises the official documentation and says whether usi3d has already verified it on a machine.
Any resin printer (2 guides)
- Hollow or cup-shaped parts: suction effect and drain holes
Hollow or bowl-shaped parts get holes or ruptures in their walls, separated layers or parts that come loose; sometimes resin splashes when peeling or liquid resin stays…
- Supports fail or the part breaks away from them
The supports stay on the build plate but the part comes loose and drops into the vat; some supports do not form or break, and parts of the model come out incomplete or…
Anycubic (1 guide)
- Photon Mono M5s: leveling, resin, layer or dropped-print monitoring warnings
The Photon Mono M5s monitors the print with a pressure sensor and stops with a warning: «Leveling monitoring error», «Resin monitoring error», «Layered monitoring error»…
Elegoo (1 guide)
- Saturn 4 Ultra 16K: cold resin or «Resin heating anomaly» message (heated resin tank)
In a cold room, the Saturn 4 Ultra 16K fails its prints: the base does not stick to the build plate or the supports come away from the model.
More “Resin” problems
Guides by brand
Can't find your case?
Tell usi3d's AI about your case: choose your printer, describe what you see and add photos if you like. It proposes checks step by step, with their sources.