Frozen screen or restarts
4 usi3d guides for “Frozen screen or restarts”, each with the likely causes, how to check which one is yours and the step-by-step fix, with each manufacturer's official sources.
One applies to any FDM printer and 3 are for Creality printers.
Each guide summarises the official documentation and says whether usi3d has already verified it on a machine.
Any FDM printer (1 guide)
- Frozen screen, garbled symbols or restarts in the middle of a print
The screen freezes or goes blank, shows strange symbols, or the printer restarts or stops mid print.
Creality (3 guides)
- Ender 3 V3 or V3 Plus: the hotend does not heat (error 2564 or 111) or it restarts while heating
The Ender 3 V3 or V3 Plus shows «Error, key: 2564, the extruder is not heating as expected», gives error 111 at start-up or while printing (communication between the…
- Ender 3 V3 SE: nozzle or bed temperature too low or too high, or it restarts while heating
The Ender 3 V3 SE reports that the nozzle or bed temperature is too low (it does not reach the set temperature in time) or too high (usually right after switching on)…
- K1: update not found, update fails or it stays on the start screen (memory full)
On a K1 series printer, the online (OTA) update says «You are currently on the latest version» even though a newer one exists, the update fails, or the printer stays on…
More “Electronics” problems
Guides by brand
Can't find your case?
Tell usi3d's AI about your case: choose your printer, describe what you see and add photos if you like. It proposes checks step by step, with their sources.